HOMAG KAL 610/23/DE Single Sided Olepovačka hrans

Assembled and inspectable machine in operation at Ferwood warehouses
Ideal machine for the production of tops, fire doors and heavy panels. 
Equipped with double track to increase the support surface and prevent panel movement. 
Automatic introduction system to introduce the panel squarely. 
Machine equipped with 3 gluing systems EVA and PUR

Type of edging Thin edge Thick edge Solid wood
Gluing System EVA Hotmelt PUR
Premilling Unit yes
Corner Rounding Unit yes
Max feed speed 40 m/min
Maximum panel thickness 60 mm
Operating Units 10 nr
Min. panel height 8 mm
Max. panel height 60 mm
Min. panel width 85 mm
Min. edge thickness 0.4 mm
Max. edge thickness 12 mm
Max. forward feed speed 40 m/min
Top pressure yes
Pressure with rubber belt
Panel support guides yes
Infeed panel alignment system yes
No. Panel Sizing / Milling units 1
NO. PANEL SIZING / MILLING UNITS 1
Unit : pre-milling unit
automatic timed intervention : yes
motor power : 4 KW
r.p.m. : 8640 RPM
Lamps to preheat the side of the panel yes
Edge coil magazine yes
no. positions 9
Gluing system yes
glue pot for EVA hot melt glue yes
glue pot for PUR glue yes
premelter for EVA hot melt glue yes
premelter for PUR glue yes
Roller set to press the edge yes
no. pressure roller 7+7
with positioning by NC yes
No. Edge Processing Units 7
NO. EDGE PROCESSING UNITS 1
Processing Unit : top and bottom rough trimming
no. motors : 2
NO. EDGE PROCESSING UNITS 2
Processing Unit : end trimming
Constructor model : HL 84
no. motors : 2
Max. machining speed : 25 m/min
motor power : 0.8 KW
r.p.m. : 12000 RPM
NO. EDGE PROCESSING UNITS 3
Processing Unit : fine trimming to trim and round
Constructor model : MF 21
no. motors : 2
with positioning by NC : yes
motor power : 0.55 KW
r.p.m. : 11360 RPM
NO. EDGE PROCESSING UNITS 4
Processing Unit : Corner rounding
Constructor model : FK 31
no. motors : 1
with positioning by NC : yes
Max. machining speed : 20 m/min
motor power : 0.75 KW
r.p.m. : 12000 RPM
NO. EDGE PROCESSING UNITS 5
Processing Unit : edge scraping
Constructor model : MN 21
with positioning by NC : yes
NO. EDGE PROCESSING UNITS 6
Processing Unit : glue scraping
Constructor model : FA 10
NO. EDGE PROCESSING UNITS 7
Processing Unit : buffing
no. motors : 2
motor power : 0.25 KW
Spray unit yes
Units fitted on overtables yes
Control system POWER CONTROL PC 22
Bar code reader yes
Safety standard CE mark yes Zobrazit překlad