HOMAG KAR 310/8/A20/S2 Single Sided Edgebanders

Assembled and inspectable machine in operation at Ferwood warehouses

Max. panel height 60 mm
Min. panel length 100 mm
Min. panel width 55 mm
Min. edge thickness 0.3 mm
Max. edge thickness 20 mm
Max. forward feed speed 18 m/min
Pressure with rubber belt
Panel support guides 
with positioning by NC 
Infeed panel alignment system 
NO. PANEL SIZING / MILLING UNITS 
Unit : pre-milling unit
automatic timed intervention
motor power : 3 KW
r.p.m. : 9000 RPM
Lamps to preheat the side of the panel
Edge coil magazine 
no. positions 6
Gluing system 
glue pot for EVA hot melt glue 
premelter for EVA hot melt glue 
Roller set to press the edge 
no. pressure roller 7
with positioning by NC 
No. Edge Processing Units 6
NO. EDGE PROCESSING UNITS 1
Processing Unit : end trimming
Constructor model : HL 81
no. motors : 2
with positioning by NC
motor power : 0.8 KW
r.p.m. : 12000 RPM
NO. EDGE PROCESSING UNITS 2
Processing Unit : top and bottom rough trimming
no. motors : 2
motor power : 1.5 KW
r.p.m. : 12000 RPM
NO. EDGE PROCESSING UNITS 3
Processing Unit : Corner rounding
Constructor model : FK 13
no. motors : 2
automatic tool change 
with positioning by NC
motor power : 0.4 KW
r.p.m. : 12000 RPM
NO. EDGE PROCESSING UNITS 5
Processing Unit : edge scraping
Constructor model : MN 21
with positioning by NC 
NO. EDGE PROCESSING UNITS 6
Processing Unit : glue scraping
Constructor model : FA 11
NO. EDGE PROCESSING UNITS 7
Processing Unit : buffing
no. motors : 2
motor power : 0.18 KW
r.p.m. : 1800 RPM
Spray unit 
Control system PC 22